Husqvarna Automower Error 056 — Outside Working Area

What it means

Error 056 means the Automower found itself outside the defined boundary.
Carry it back to the charging station and check for loop wire damage.

How to Fix It

Carry the mower back to the base

Manually pick up the mower and place it on the charging station contacts.
Make sure it docks properly and begins charging.
Check for loop wire breaks

Error 056 is often preceded by an unnoticed Error 042 (no loop signal).
Walk the boundary wire to look for cuts or damage.
Inspect where the mower stopped

Examine the point where the mower left the boundary.
A shallow wire installation or a narrow passage may have allowed the mower to cross.
Adjust boundary wire placement

In problem areas, re-stake the boundary wire so it is flush to the ground and add extra pegs at corners and narrow passages.
Recalibrate the working area

If the mower repeatedly escapes the same spot, use the Automower CONNECT app or keypad to recalibrate the search wire route for that zone.

Frequently Asked Questions

Why did my Automower go outside the boundary?

The most common reason is a weak loop signal at a curve or narrow passage.
Other causes include a partial wire break, terrain changes from frost heave, or wire installed too shallow.

How do I prevent Error 056 from happening again?

Ensure the boundary wire is staked every 20–30 cm, flush to the ground, and undamaged.
Add extra stakes at corners and narrow passages.

Will the mower find its way home on its own after Error 056?

No — once outside the boundary the mower stops and waits.
You must carry it back to the charging station manually.